To validate the installation, the DFU driver functionality can be verified by following the FAQ instructions provided in how to check if the DFU driver is functional. In case of issue, refer to How to proceed when the DFU driver installation fails on Windows host PC. It is located in the DFU driver folder, \Drivers\ DFU_Driver. This driver (installed by STM32 Bootloader.bat) is provided within the STM32CubeProgrammer release package. Run the “STM32 Bootloader.bat” file to install the STM32CubeProgrammer DFU driver and activate the STM32 microprocessor device in USB DFU mode. To allow STM32CubeProgrammer to access the USB port through low-level commands, proceed as follows: This is achieved by typing the following command from the host PC terminal: The libusb1.0 package (including USB DFU mode) must be installed to be able to connect to the board via the USB port.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |